![]() ![]() A maintenance program must also be established by a qualified person and must be followed to ensure that the machine is safe to operate. ![]() ![]() In order to promote proper usage of the machine, it is mandatory that a daily routine be established based on instructions given in this section. SAFETY PRECAUTIONS 1.1 GENERAL 1.2 DRIVING/TOWING This section prescribes the proper and safe practices for major areas of machine usage. SECTION 1 - SAFETY PRECAUTIONS SECTION 1. TABLE OF CONTENTS (Continued) TABLE OF CONTENTS (continued) SUBJECT - SECTION, PARAGRAPH 5.13 PAGE NO. 1-1 Driving/Towing.1-1 Electrocution Hazard. TABLE OF CONTENTS TABLE OF CONTENTS SUBJECT - SECTION, PARAGRAPH SECTION PAGE NO. Instruction and warning placards must be legible.įOREWORD REVISON LOG Original Issue Revised 2-12 and 2-13 5-3 3-6 3-10 d - May, 1998 AugUpdated 11-2-99 Updated 2-16-00 Updated 9-19-00 Updated 4-24-02 – JLG Lift – 3120868 Load limits specified by the manufacturer shall not be exceeded. All procedures herein are based on the use of the machine under proper operating conditions, with no deviations from original design intent. All personnel in the platform shall, at all times, wear approved fall protection devices and other safety gear as required. REMEMBER ANY EQUIPMENT IS ONLY AS SAFE AS THE OPERATOR.įOREWORD This page left blank intentionally.įOREWORD 5. YOUR OPERATING MANUAL IS YOUR MOST IMPORTANT TOOL - Keep it with the machine. All information in this manual should be READ and UNDERSTOOD before any attempt is made to operate the machine. It is important to over-stress proper machine usage. Operators and Safety Manual Model 450A 450AJ 3120868 April 24, 2002įOREWORD FOREWORD The purpose of this manual is to provide users with the operating procedures essential for the promotion of proper machine operation for its intended purpose. SECTION - 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCEĦ.1 INTRODUCTION. INCIDENT NOTIFICATION.ĮMERGENCY OPERATION. 4-10 4.9 OSCILLATING AXLE LOCKOUT TEST (IF EQUIPPED). 4-1Ĥ.2 OPERATING CHARACTERISTICS AND LIMITATIONS. SECTION - 3 - MACHINE CONTROLS AND INDICATORSģ.1 GENERAL. 2-10Ģ.4 OSCILLATING AXLE LOCKOUT TEST (IF EQUIPPED). 2-9Ģ.3 HORIZONTAL AND CAPACITY LIMIT SWITCHES. 2-1Ģ.2 PREPARATION, INSPECTION, AND MAINTENANCE. SECTION - 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTIONĢ.1 PERSONNEL TRAINING. 6.7 Propane Fuel System Pressure Reliefġ.1 GENERAL. ![]() GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE Boom Movement Prevented By Boom Control System.4.9 Oscillating Axle Lockout Test (If Equipped).4.2 Operating Characteristics and Limitations.2.4 Oscillating Axle Lockout Test (If Equipped).2.3 Horizontal and Capacity Limit Switches.2.2 Preparation, Inspection, and Maintenance.USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |